「Dollection」Water Base Transfer Face-Up Sticker #No.5
 
THIS IS A WATER BASE TRANSFER FACE-UP STICKER, NO DOLL IS INCLUDED
 
Suitable for 1/6 size Imomo Doll
 
Introduction
1) Put a layer of MSC on the head, and leave it dry.
2) Soak the sticker in water for a few seconds, then use your fingertips to check if it can be separated from the backing paper. Apply some water to the face to adjust the sticker's position.
3) Once the position is determined, use a cotton swab to remove excess water, and then apply softener to soften the sticker.
4) Leave the head for 3-5 hours until it is completely dry.
5) Apply another layer of MSC, apply your blush, and seal it again with a final layer of MSC.
 
*Attention Point*
There may be a paint smell upon receiving it. It is recommended to let it ventilate for a few days. Due to the back panel of the desk being fixed with only two screws, please avoid pushing it. After assembly, position it against the wall. 
 
The paint used on the desk drawers and other parts is the same as the table, but due to the wood color of the boards, there will be a color difference.
 
 
Production Time: 2months
 
✨ Free Shipping over USD150 to selected country only.
✨ Layaway available.